|Mohican Models GP-38 High hood shell
|Page 1 of 1|
|Author:||Cadman [ Tue Jul 22, 2014 10:07 am ]|
|Post subject:||Mohican Models GP-38 High hood shell|
These Shapeways 3D printed shells are available from AllanGBorg's Mohican Models store front.
They are only available printed in Frosted Ultra Detail (Matte translucent plastic that showcases fine and intricate details) for $17.49.
These are a good start for a high hood conversion, but the grills would look better if they were photo etched as the 3D printing is not nearly as good in detail.
|Page 1 of 1||All times are UTC - 6 hours [ DST ]|
|Powered by phpBB® Forum Software © phpBB Group